Installation And Connection; Recommended Installation Position; Reset Button; Dc-In/Data Transfer Port - Kenwood DRV-A601W Instruction Manual

14. CAM-IN
The device can be connected with the rear camera KCA-R200.(optional accessory)
15.

DC-IN/Data transfer Port

By connecting the device with the supplied cigar lighter adapter cable you are
able to charge the device. This will also be utilized to let you connect the USB cord to
your computer. You can either connect the cigar lighter adapter cable with the device
or magnetic connector.
16.

Reset Button

On the rare occasions the device has a problem, use the reset button to shut down
the device. Simply press the reset until the device turns off and press power button to
turn on.

Installation and Connection

Recommended installation position

Install the device in a position where it will not block the front view of the driver
•
(position where hidden by the rear-view mirror).
• Install the device so that it is within the wiping range of the wiper.
Mounting the device to the center of the windshield behind the rear-view mirror
•
will facilitate optimal video recording.
Left-hand Drive
Caution
When passing the power cord through the front pillar or another part, observe the
points below when performing the wiring work.
Wire the power cord farther forward or farther rearward than the airbag so that it
•
does not interfere with the airbag.
In the case of a vehicle in which the front pillar cover is fixed in place with special
•
clips or the like, the clips may need to be replaced after you remove the front pillar
cover. For how to remove the front pillar cover, the availability of replacement
parts and other information, contact the vehicle dealer.
Fix the power cord in place with commercially available soft tape or the like so that
•
it does not interfere with driving.
Right-hand Drive
13