Replacing The Oven Lights; Replacing A Light Bulb - Dacor Millennia DO230S Use And Care Manual

Replacing the Oven Lights

• Make certain that the oven and light bulb are cool and
that power to the oven has been turned off before
replacing the light bulb.
• Always ensure that the lens cover is in place when
using the oven. The lens cover protects the bulb
from breakage caused by high oven temperatures or
mechanical shock.

Replacing a Light Bulb

Light bulb replacement is considered to be a hom-
eowner maintenance operation.
ERD Series Ranges:
ERD range models have halogen oven lights to
enhance the view into the oven. The light assembly
consists of a removable lens cover and 10-watt 120
Vac halogen bulb, as well as a light fixture housing.
1. Turn off the power at the main power supply.
2. Remove the lens cover from the housing by pull-
ing straight out. In some cases the lens cover
may be tight enough to require the use of your
light lens pry stick. It comes packed inside of
your broiler pan along with the use and care
manual. Use the lens pry stick with caution.
Do not cause uneven stress on the lens cover.
Gently insert the pointed end of the pry stick
under the center edge of the lens cover on the
side facing the oven door. Hold your hand under
the lens for support then pry out to remove.
3. Pull the light bulb out and replace it with a
special 10-watt halogen bulb rated for use in a
self-cleaning oven. Use Dacor Part No. 86364
available from any authorized Dacor parts dis-
tributor or at www.everythingdacor.com.
4. Reinstall the lens cover by aligning the cover
over the opening and gently pressing it into its
original position. IMPORTANT: Be sure to line
up the cutout in the lens with the light socket.
Light Socket
(ERD Series Models)
Care and Cleaning
CAUTION
5. Turn the power back on at the main power
supply.
6. Reset the time of day. (Refer to the
Your Range section).
EGR Series Ranges:
1. Turn off the power at the main power supply.
2. Remove the threaded lens cover from the hous-
ing by rotating counterclockwise.
3. Pull the light bulb out and replace it.
4. Reinstall the threaded lens cover by rotating
clockwise.
Light Socket (EGR Series Models)
5. Turn the power back on at the main power
supply.
6. Reset the time of day. See the
Range section.
19
Setting Up
Setting Up Your