Miele DA 3466 Operating And Installation Instructions page 33

To avoid scratching the deflector
plate, do not remove the protective
film between the deflector plate and
the casing until the rangehood has
been placed in the housing unit.
 Installation of the rangehood is
carried out without the grease filter
placed in position. If the grease filter
has already been fitted, then it should
be removed (see "Cleaning and
care").
 When fitting a 90 cm wide rangehood
in a 60 cm wide wall unit, whilst the
deflector plate is pulled out, unscrew
the two deflector plate spring
mounts.
 Lift the appliance up into the housing
unit from below until the spring
mounts at the side engage in the
brackets.
 Push the rangehood back against the
spacer strip.
 Note for dismantling the rangehood:
Undoing the screws on the left and
right inside the housing releases the
spring mounts, allowing the appliance
to be removed from the unit.
Installation
33