Miele DA 3460 Operating And Installation Instructions
  1. Manuals
  2. Brands
  3. Miele Manuals
  4. Ventilation Hood
  5. DA 3460
  6. Operating and installation instructions

Miele DA 3460 Operating And Installation Instructions

Hide thumbs Also See for DA 3460:
Table of Contents

Advertisement

Quick Links

See also: Instruction and Installation Manual , Operation & Installation Manual
Operating and Installation instructions
Rangehood
DA 3460
DA 3490
en - AU, NZ
To avoid the risk of accidents
or damage to the appliance,
it is essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 09 727 360

Advertisement

Table of Contents
loading

Related Manuals for Miele DA 3460

Summary of Contents for Miele DA 3460

  • Page 1 Operating and Installation instructions Rangehood DA 3460 DA 3490 en - AU, NZ To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time.

  • Page 2: Table Of Contents

    Contents Caring for the environment ......... . 3 Warning and Safety instructions .

  • Page 3: Caring For The Environment

    Caring for the environment Disposal of the packing Disposal of your old appliance material or machine The transport and protective packing Electrical and electronic appliances / has been selected from materials which machines often contain materials are environmentally friendly for disposal which, if handled or disposed of and can normally be recycled.

  • Page 4: Warning And Safety Instructions

    Any other usage is at the owner's risk. requirements. Inappropriate use Miele cannot be held liable for damage can, however, lead to personal resulting from incorrect or improper use injury and damage to property.

  • Page 5: Technical Safety

    Consult Miele authorised person in accordance a qualified electrician if in any doubt. with current national and local safety The electrical safety of this regulations.
  • Page 6 Warning and Safety instructions Do not connect the appliance to the Using at the same time as other mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
  • Page 7 Warning and Safety instructions There must be adequate ventilation of the room when the rangehood is used The overall ventilation condition at the same time as appliances burning of the dwelling must be taken into gas or other fuels. account. If in any doubt, the advice of a competent builder or, for gas, a In order to ensure safe operation, and qualified gas fitter must be sought.

  • Page 8: Correct Use

    Warning and Safety instructions Correct use The filters should be regularly cleaned or changed as appropriate. Never use an open flame beneath Saturated filters are a fire hazard. See the rangehood. To avoid the danger of "Cleaning and care". fire, do not flambé or grill over an open flame.

  • Page 9: Correct Installation

    Safety regulations prohibit the fitting of a rangehood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from Miele or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.

  • Page 10: Description Of The Appliance

    Description of the appliance...
  • Page 11 Description of the appliance a Exhaust socket C 150 mm h On/Off touch control for the fan b Controls i Touch controls to select the fan power setting c Grease filter j Touch control for the cooktop d Pull-out deflector plate lighting e Cooktop lighting f Charcoal filter...

  • Page 12: Description Of The Functions

    Charcoal filters are available to order appliance must be fitted in the exhaust from Miele or via the internet at socket in the motor unit. www.miele-shop.com (check availability). See back cover for contact details and Having a non-return flap fitted in the "Technical Data"...

  • Page 13: Operation

    Operation The rangehood is operated by pulling To switch the fan off out and pushing in the deflector plate. ^ Push the deflector plate back in. The next time the deflector plate is pulled To switch the fan on out, the rangehood will operate at ^ Pull out the deflector plate.
  • Page 14 Operation Automatic switch-off of the Intensive Safety switch-off setting If the rangehood hasn't been operated You can set the Intensive setting so that for 10 hours, the fan will switch off it always only runs for 10 minutes before automatically. The lighting will remain switched on.

  • Page 15: Cleaning And Care

    Housing To prevent immediate resoiling, the General notes Original Miele care product for stainless steel can be purchased from Miele or at The surfaces and controls are www.miele-shop.com (depending on susceptible to scratches and country). Apply sparingly with a soft abrasion.

  • Page 16: Grease Filter

    Cleaning and care Controls The controls may suffer discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the "General notes" on cleaning earlier in this section. Do not pull the grease filter downwards to remove while it is at Do not use stainless steel cleaning the back of the canopy.
  • Page 17 Ensure the spray arm is not obstructed. ^ Do not wash at more than 65 °C. If a Miele dishwasher is being used, ^ When putting it back, make sure that select the Sensor wash programme.

  • Page 18: Fitting And Replacing The Charcoal Filter (Optional Accessory)

    It is fitted in the canopy above the grease filter. Replacement charcoal filters can be obtained from Miele or via the internet at www.miele-shop.com (depending on country). See back cover for contact details, and "Technical data" for type and reference number.

  • Page 19: Changing A Halogen Lamp

    Cleaning and care Changing a halogen lamp ^ Pull out the deflector plate, and remove the grease filter as described earlier. ^ Switch off the fan and the lighting. Exercise caution when changing halogen lamps. They get very hot during use, and remain hot for some time after being switched off.

  • Page 20: Appliance Dimensions

    Appliance dimensions DA 3460 DA 3490...
  • Page 21 Appliance dimensions 1) In extraction mode: when measuring Safety distances between cooktop for the height of the wall housing unit and rangehood (S) and the cut-out, account must be taken of any accessories fitted, e.g. silencer, The minimum safety distances DSM module.

  • Page 22: Installation

    Installation Installation accessories...
  • Page 23 Installation a 1 exhaust connection for exhaust ducting C 150 mm. b 1 non-return flap 8 screws 4 x 15 mm for fitting into the exhaust socket on for securing the rangehood to the wall the motor unit (not needed for unit.
  • Page 24 Installation...

  • Page 25: Positioning The Appliance In The Wall Housing Unit

    Installation Positioning the appliance in the wall housing unit To position the appliance correctly, cut the spacer strip to the required depth T, and then attach it to the back of the appliance. T= Wall unit depth K minus depth of ^ Screw the spacer strip to the bottom appliance G of the sides of the housing, flush with...
  • Page 26 Installation Do not remove the protective film between the deflector plate and the appliance housing until the ^ Screw the brackets onto the right and rangehood has been placed in the left inside walls of the housing unit as housing unit. shown.
  • Page 27 Installation Note for dismantling the rangehood: Undoing the screws on the left and right inside the housing releases the brackets, allowing the appliance to ^ When installing a 90 cm wide be removed from the unit. appliance in a 60 cm wide wall unit, unscrew the brackets on the ^ Push the rangehood back against the deflector plate while it is pulled out.
  • Page 28 Installation ^ Align the housing unit and screw the ^ Loosen the fixing bracket screws on brackets onto the housing. the top of the housing. ^ Push the brackets onto the rear of the wall unit or the wall. ^ Secure the spacer strip to the back of the appliance from behind using 4 plastic rivets as shown.

  • Page 29: Attaching The Lightshield

    Installation Attaching the lightshield Adjusting the building-in depth ^ Attach the lightshield (if using). A DML 400 installation kit, available as an optional accessory, is required for this. ^ The position of the deflector plate Follow the installation instructions supplied. can be brought forward by up to 35 mm using the adjusting screws on Warning: Failure to install the screws or...

  • Page 30: Fitting The Grease Filter

    Installation Fitting the grease filter Set up for extraction mode ^ Remove the protective strip around the edge of the grease filter. ^ In case the on-site ventilation system Fit the grease filter. does not have a non-return flap, a non-return flap is supplied with the ^ To do this, pull out the deflector appliance.

  • Page 31: Set Up For Recirculation Mode

    For this, a conversion kit DUU 151, available from Miele, is required. You will also need a charcoal filter (see ^ Place the exhaust ducting on the "Technical data").

  • Page 32: Electrical Connection

    Installation Electrical connection Refer to the notes in “Electrical connection” and “Warning and Safety instructions” before connecting to the electricity supply. ^ Plug the connection cable into a wall socket. ^ Fit the conversion kit as described in the installation instructions supplied with the kit.

  • Page 33: Connection For Air Extraction

    Connection for air extraction – The exhaust ducting should not be Important: To avoid the danger of kinked or compressed. toxic fumes, please observe the – Ensure that all connections are Warning and Safety instructions. strong and airtight. This is especially crucial when using the rangehood at the same time as –...

  • Page 34: Condensate Trap

    Connection for air extraction Condensate trap (optional accessory) For installations in areas where the exhaust ducting is exposed to cold temperatures, we recommend insulating the exhaust ducting and installing a condensate trap to collect and evaporate any condensate which may occur. Condensate traps are available for C 125 mm or C 150 mm ducting.

  • Page 35: Silencer

    Connection for air extraction Silencer (DASD 150, optional accessory) ...with air extraction: The silencer not only reduces noise from the fan, but also sounds from outside (e.g. traffic noise). To achieve even further reductions in For this reason, the silencer must be noise levels, a special silencer can be positioned as close as possible to where fitted in the ducting system.

  • Page 36: Electrical Connection

    Electrical connection If the switch is not accessible after All electrical work should be installation, an additional means of undertaken by a suitably qualified disconnection must be provided for all and competent person in strict poles. accordance with current national For extra safety, it is advisable to install and local safety regulations.

  • Page 37: Operation With Control Module Dsm 400

    Operation with control module DSM 400 The Miele DSM 400 can be used to Installation combine the rangehood with other components. Follow the installation instructions suppled. Warning: Failure to install the screws or fixing device in accordance with the instructions may result in electrical hazards.

  • Page 38: After Sales Service

    In the event of a fault which you cannot correct yourself, please contact: – Miele You will find the telephone number and address of Miele on the back cover of the manual. Please quote the model and serial number when contacting Miele. These...

  • Page 39: Technical Data

    Weight DA 3460....12.5 kg DA 3490....14.5 kg...
  • Page 40 Alteration rights reserved / 3513 M.-Nr. 09 727 360 / 01...

This manual is also suitable for:

Da 3490

Table of Contents