Table of Contents
Advertisement
8.2 Changing the cutting tool
8.2.1 Use
protective gloves when replacing
8.2.2 Cut the electric connection of the machine.
8.2.3 Open the upper protection cover. (FIGURE 2-NO: 7)
8.2.4 With the help of 6 Allen key (given with the machine), demount the bolt (FIGURE 8-NO: 31) from its location..
Take the washer (FIGURE 8-NO: 32) and the exterior coupling (FIGURE 8-NO: 33) to the outside.. Take the
saw cutter group (FIGURE 8-NO: 35) over the rotor shaft (FIGURE 8-NO: 36) by taking, replace it with a new
group saws After replacing the saw cutters, do the opposite of the demounting procedure and tighten the bolt.
WHEN REPLACING THE MILLING CUTTER GROUP, ENSURE THE CUTTERS ROTATE IN THE
CORRECT DIRECTION
.
cutting tool.
34
Advertisement
Table of Contents
