Changing The Cutting Tool - YILMAZ KM 213 Manual

8.2 Changing the cutting tool

8.2.1 Use protective gloves when replacing
8.2.2 Cut the electric connection of the machine.
8.2.3 Open the upper protection cover. (FIGURE 2-NO: 6)
8.2.4 With the help of 6 Allen key (given with the machine), demount the bolt (FIGURE 10-NO: 43) from its location..
Take the washer (FIGURE 10 NO: 44) and the exterior coupling (FIGURE 10 NO: 45) to the outside.. Take the
saw cutter group (FIGURE 10 NO:47) over the rotor shaft (FIGURE 10 NO: 48) by taking, replace it with a new
group saws.. After replacing the saw cutters, do the opposite of the demounting procedure and tighten the bolt.
(ON KM 213 MODELS)
8.2.5 Push the blade-changing button (FIGURE 6 / 9 NO: 25). Bearing tightening the saw group will go up (FIGURE 9
NO: 41). Take the idle tightening bearing and take out the saw group. Mount the saw group, prepared according
to the profile to be processed, on the shaft. Push the blade-changing button again and mount the tightening
bearing that you took off. (ON KM 215 MODELS)
WHEN REPLACING THE MILLING CUTTER GROUP, ENSURE THE CUTTERS ROTATE IN THE
CORRECT DIRECTION
.
cutting tool.
37