Using Your System; Arming; Disarming; Disarming Without A Touch Key - Directed Electronics Viper 106V Owner's Manual

using your system

Use the procedures below to arm and disarm the immobiliser.

arming

When the vehicle's ignition is turned Off, the immobiliser will start a 30-
second timer and the LED will flash at a rapid rate. During this period the
immobiliser arming can be canceled by turning the vehicle's ignition On.
After the 30-second timer expires, the immobiliser is armed (starter,
ignition, and fuel pump are immobilised). The LED flashes once per sec-
ond when in the armed state.

disarming

To disarm the system, insert the touch key into the touch key receptacle
and hold until the LED illuminates continuously for 1-second. Remove the
touch key the LED will extinguish. The system is now disarmed.

disarming without a touch key

This procedure allows you to disarm the system without the touch key
should it be lost, damaged, or disabled. In order to disarm without a
touch key, you must have the vehicle's ignition key, and have the PIN
code.
1. Turn the ignition On, then Off, 6-times.
2. Turn the ignition On a 7
6
time.
th
© 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .