Directed Electronics Viper 106V Owner's Manual page 10

3. Wait 5-seconds.
4. The LED will illuminate continuously for 3-seconds.
5. The LED will then extinguish for 1.5 seconds.
6. The LED will then flash 10 times (0.5 second on, 0.5 second off).
7. The LED will turn off for 2-seconds.
8. The LED will then flash in 10 flash cycles repeatedly (as
described in step 6 and step 7).
9. To enter the first digit of your PIN code it is necessary to
turn the ignition Off once the number of flashes equals the
first digit of your PIN (during the 10-flash cycle described in
step 6). If you miss the count, let the system continue to
the next 10-flash cycle.
10. The LED will flash to indicate the number you selected. This
will repeat once.
11. Turn the ignition back On (the LED will begin flashing in
groups of 10 again).
12. Repeat steps 9, 10, and 11 for the 2
PIN number.
13. Once the 4-pin code is entered correctly, the system will dis-
arm and the LED will extinguish.
n n o o t t e e : : For example, turning the ignition Off after the first flash of the 10
flash cycle, enters a number of one (1). Turning the ignition Off after
the 4 flash, enters a number of four (4). Turning the ignition Off after
th
the 10 flash, enters a number of zero (0).
th
n n o o t t e e : : If the entered code is incorrect, the LED will illuminate continu-
ously for 3-seconds and the system will exit Disarming Without a Touch
Key mode. You will have to start from the beginning again to enter the
correct code.
© 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
, 3 and 4 digit of the
nd rd th
7