O P E R A T I O N O F S T A N D A R D F E A T U R E S; Switch Panel - Grady-White 330 Express Owner's Manual

3 3 0 E
X P R E S S

O p e r a t i o n O f S t a n d a r d F e a t u r e s

S P
WITCH ANEL
At the helm you will find an accessory switch panel. An additional switch panel is located
above the livewell in the cockpit. The livewell, washdown, and spreader lights switches make up
this cockpit switch panel. Refer to the "Accessory Wiring Color – Fuse/Breaker Sizes" on
page 6–10 for overcurrent protection amperage ratings for each circuit. Also see "12 Volt DC
Helm Switch Panel Diagram" on page 8–44 and "12 Volt DC Cockpit Switch Panel Diagram" on
page 8–51 for switch panel wiring diagrams. Consult your dealer for specific information or
questions on the accessories included on your boat.
• Aft and Forward Bilge Pump
These two-way switches serve as manual switches for each bilge pump. These switches
operate independently of each other. Two circuit breakers located above each switch provide
over-current protection at the panel for each bilge pump circuit.
• Cockpit Lights
The cockpit lights provide illumination in the cockpit and helm areas. A circuit breaker
located above this switch provides over-current protection for this circuit.
• Electronics Box
This momentary switch activates the lift which opens and closes the raisable electronics box
at the helm. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Horn
This momentary switch activates a horn which meets the requirements of the USCG for
sounding devices. A circuit breaker located above this switch provides over-current protection
for this circuit.
• Livewell
This switch activates the livewell pump and light. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Navigational/Anchor Lights
This three-position switch (NAV-OFF-ANC) changes the lighting configurations to running or
anchor lights. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Spreader Light
This switch activates the hard top spreader lights. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Washdown
This switch activates the washdown system. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Windlass
This switch operates the anchor windlass. Depress the top of the switch to raise the windlass
and the bottom of the switch to lower the windlass.
8–2