To Enter Valet Mode; To Exit Valet Mode - Directed Electronics Automate 640M Owner's Manual

To Enter Valet Mode
®
1. Your vehicle should be able to start and the ignition must be
ON.
2. Turn the IGNITION key to the OFF position and then to the
START position and HOLD.
3. While holding the IGNITION key, within 2-seconds, simulta-
neously press buttons
4. Wait 30-seconds and start the vehicle a few times to ensure
the system is in Valet
Your vehicle is now in Valet
Valet ® mode is exited.
To Exit Valet Mode
®
1. Turn the IGNITION key to the START position and HOLD.
2. Simultaneously press buttons
transmitter. This will exit Valet
3. Turn the IGNITION key to the OFF position and wait for at
least 30-seconds.
4. Attempt to start the vehicle. The vehicle should NOT start
indicating your system has entered the armed state and is
active.
© 2004 directed electronics, inc.
and
® mode.
® mode, allowing the vehicle to start until
and
mode.
®
on your transmitter.
once on your
5