OPERATION
Note: Do not pull starter rope out to maximum position. Do not allow
recoil handle to snap back against the casing. If engine does
not start after 5 pulls, repeat instructions.
Starting Warm Engine
Make sure the bar and chain are free from any obstruction when
starting the chain saw.
1.
Move chain brake lever fully
FORWARD to LOCK chain brake
before starting.
2.
Confirm there is fuel and chain
oil in the tanks.
3.
Move ignition switch forward to
"RUN" position.
4.
Securely hold the chain saw as
shown and pull starter handle.
32
Chain Brake LOCKED
Shown with optional
Kick Guard
START / RUN
Chain Brake LOCKED
Shown with optional
Kick Guard
© 11/19 ECHO Incorporated
CS-2511T
TM
Ignition Switch
TM
X7503332503