Echo CS-2511T Operator's Manual page 23

CS-2511T
Guide Bar and Saw Chain Installation / Removal
1. Release the spark plug cover
latch with the T-Wrench.
2. Disconnect the spark plug wire.
3. Move the chain brake lever (A)
(Front hand guard) fully
REARWARD (UNLOCK chain
brake) to remove or install the Bar/
Clutch Cover (C).
4. Remove Bar/Clutch Cover Nut (B)
and remove Bar/Clutch Cover (C).
5. Mount Guide Bar (D) on Guide
Bar Stud (E) and slide toward
Clutch Drum (F) to make Saw
Chain (G) installation easier.
6. Install Saw Chain (G) around
Clutch Drum (F) and Guide Bar
(D) as shown, with cutters on top
of guide bar facing forward.
7. Install Bar/Clutch Cover (C) over
Guide Bar Stud (H). Make sure
chain tension Adjuster Pin (J) fits
into the Guide Bar Adjuster Slot
(K), and Brake Band (L) is
positioned around Clutch Drum
(M). Tighten Bar/Clutch Cover Nut
(B) finger tight.
Note: Align the brake connector of the Bar/Clutch Cover (C) to the
groove on the side of the brake lever (Front hand guard).
X7503332503
© 11/19 ECHO Incorporated
DESCRIPTION
SPARK PLUG COVER LATCH
RELEASE LATCH
T-Wrench
ENGAGE LATCH
C
B
F
L
J E K G
C
A
D
23