Setup And Operation - Snailax SL-363M Use & Care Manual

Setup and Operation

1. If needed, fasten the strap around the back of a chair or other support.
2. Connect the adapter cable to the corresponding cable at the side of the mat.
3. Plug the home adapter into an outlet.
4. Turn on the device using the controller (instructions on page 5).
5. Place the controller in the pouch at the side of the cushion when finished.
• Remove the adapter from the outlet when not in use.
• This device will switch off automatically after 30 minute timer run out.
• Do not setup or use the massager in a bathroom or similary wet /
damp areas.
• Please just use the provided home adapter.
• For your own safety we equip the massage mat with a protection against
over-heating.
Heat is created in the motors when placed under great stress and excessive
pressure. Before this could create any risk and after a runtime of 30 Minutes.
The massager will switch off automatically and will only allow switching on
again after an appropriate downtime.
• Likewise, you should allow your body some rest periods. To avoid straining
your muscles too much, we recommend to not exceed a continuous massage
of 30 Minutes.
Mat side
Adaptor side
3