Setup And Operation; Controller Instructions; Vibration Massage - Snailax SL-522V2 Use & Care Manual

Setup and Operation

1. Connected the adapter cable to the cable on the foot massager.
2. Plug the home adapter into an electric outlet.
3. Turn on the device by operating remote controller(refer to controller instructions.).
4. When finished unplug the adapter from the outlet.
• The device will automatically switch off after 30 minutes timer run out.
• Do not setup or use the device in a bathroom or similary wet/damp areas.
• Ensure the device is not exposed to direct sunlight or placed near sources of heat.

Controller instructions

Power:
Press to turn the
device on or off.

Vibration massage:

Press to change the Mode
between mode I to III.
The vibration massage
can be turned on
independently.
Note:
This product produces a warming heat. It is not intended to be used as a therapeutic
heating pad. Please allow a few minutes to reach maximum temperature.
The maximum temperature: approx 130F.
POWER
INTENSITY I/II/III
MODES I/II/III
HEAT I/II
3
Intensity:
Press to choose Low/
Medium/High intensity
of vibration
Heat:
Press to activate the
heat function, you may
cycle through High, Low
and off settings.
The heat can be turned
on independently.