Installing The Crossover - Orion C5.2 Owner's Manual

FULLY FLUSH MOUNTING
Step 1: Determine where the tweeter will be mounted. Make sure there is
a flat area large enough for the tweeter and no obstructions behind
the area.
Step 2: Mark with a pen the hole needed for the tweeter.
Step 3: Be sure the hole is large enough for the tweeter housing.
Step 4: Cut the hole for the tweeter. When using factory locations, this step
can be passed. A hole can be cut either with a pair of metal tin snips
or a hole saw corresponding to the size of the tweeter listed below.
• 1-3/4" Hole Saw
WARNING: Window mechanisms and electrical wires have a nasty
habit of hiding where you least expect. CHECK BEFORE YOU DRILL!
Step 5: Install tweeter in flush mount housing.
Step 6: Install tweeter and housing in the hole cut for mounting, so that the
beauty ring is flat with the front of the surface.
Step 7: Use the supplied mounting ring to secure the housing to the surface.

INSTALLING THE CROSSOVER

Step 1: Find a location for the crossover away from any factory or after
market electrical wires. It is recommended to mount the passive
crossover close to the amplifier. In the event you decide to upgrade
and bi-amplify the system, mounting the passive crossover close to
the amplifier would simplify the installation upgrade.
Step 2: Remove top cover of crossover housing. Don't lose it.
Step 3: Mark with a marking pen the two mounting holes.
5