Table of Contents
Advertisement
INSTALLATION
The performance of the C-Series component loudspeaker is directly proportional
to the quality of installation. Care taken during the installation process will be
rewarded with years of satisfying performance. If you are unsure about your
installation capabilities, please refer to your local Authorized Orion Dealer for
technical assistance. Orion dealers are trained professionals dedicated to
extracting the maximum performance from of your Orion system. If you decide to
install this speaker system yourself, please read the entire installation section
before starting your installation.
TOOLS OF THE TRADE
Listed are the majority of the tools required to perform the installation. Having
the proper tools will make the installation much easier. It is very difficult when
you get half way through the installation and discover that you require a
specific tool to get yourself through a particular part of the installation. Some
of these tools are necessities. Some make the job much easier.
• Marking Pen
1 /
•
" Drill Bit
4
1 /
•
" Drill Bit
8
3 /
•
" Drill Bit
8
3 /
• 3
" Hole Saw (4" woofer installation) • Needle Nose Pliers
4
• Hole Saw Arbor
7 /
• 4
" Hole Saw (5" woofer installation) • Wire Crimpers
8
5 /
• 5
" Hole Saw (6" woofer installation)
8
3 /
• 1
" Hole Saw (for flush and angle mount tweeter installation)
4
FINDING SPEAKER MOUNTING LOCATIONS
Choosing the correct speaker locations will have the greatest effect on the
sound quality of the system. There are many different considerations needed
when choosing the locations that best suit your needs. The locations must be
large enough for the speakers to fit. Care is needed to ensure that the location
you have chosen will not affect any of the mechanical or electrical operation
of the vehicle.
Determining the best location for the speakers will depend on your cosmetic
needs and your vehicle's interior. If minimal intrusion in your vehicle is
desired, factory speaker locations may be the ticket for you. Placing the
speaker in the factory location can often give very desirable results.
DOOR MOUNTING
When checking for possible speaker locations in the doors, check the
operation of the window and all assemblies. There is also a stabilizer stop bar
in between the door and the door jamb. This bar prevents the door from
opening too far. Many shade tree installers overlook this and check for
clearance only when the door is fully open.
• Electric Drill
• Phillips Screwdriver
• Volt/Ohm Meter (Optional)
• Assorted Tin Snips
• Wire Cutters
• Wire Strippers
2
Advertisement
Table of Contents
