Installing The Crossover; Specifications - Orion P5.2 Owner's Manual

INSTALLING THE CROSSOVER

Step 1: Find a location for the crossover away from any factory or after
market electrical wires. It is recommended to mount the passive
crossover close to the amplifier. In the event you decide to upgrade and bi-
amplify the system, mounting the passive crossover close to the amplifier
would simplify the installation upgrade.
Step 2: Remove top cover of crossover housing. Don't lose it.
Step 3: Mark with a marking pen the two mounting holes.
Step 4: Remove crossover and pre-drill mounting holes using a 1/8" drill bit.
WARNING: Gas tanks, fuel lines, brake lines and electrical wires have a nasty
habit of hiding where you least expect. CHECK BEFORE YOU DRILL!
Step 5: Mount the crossover using the supplied #8 screws.
Step 6: Connect the wires. Make sure the speaker wires for the midrange
go to the woofer output and the tweeter to the tweeter output. Be sure to
observe the correct polarity. Changing the polarity of the tweeter may be
necessary for optimum sound quality.
Step 7: Re-install the crossover cover.
+
T T O O A A M M P P L L I I F F I I E E R R
-

SPECIFICATIONS

Model
Nominal Impedance
Power
Continuous/Peak
Frequency Response
Sensitivity
Mounting Depth
Mounting Diameter
+
-
T T W W E E E E T T E E R R
+
W W O O O O F F E E R R
-
Orion P5.2
4 ohms
100/150
70Hz - 22kHz
87 dB
w/grille 2.75"
w/o grille 2.5"
4 / "
11
16
6
Orion P6.2
4 ohms
100/150
60Hz - 22kHz
89 dB
w/grille 3"
w/o grille 2.75"
5 / "
5
8