Table of Contents
Advertisement
User Manual
T70 2 Transmitter
Technical description
T70 2 start up
©
Danfoss | January 2019
Use the information below to properly turn the transmitter ON (OPERATION mode).
1. Place a charged battery in the transmitter. The charge must be done following the instructions of the
Battery Chargers' Manual.
2. Turn the contact key.
3. Push and pull out the STOP button.
LED will flash orange-green pulse. If the transmitter has LCD, it displays the identification of the
machine and battery level (only if it has been pre-programmed).
LED pulse
BC292360528568en-000101 | 7
Advertisement
Table of Contents
Need help?
Do you have a question about the T70 2 and is the answer not in the manual?
Questions and answers