A Message Appears In The Display At The End Of The Program Or When The Appliance Is Switched On - Miele WWH 660 Operating Instructions Manual

Frequently Asked Questions
A message appears in the display at the end of the program or
when the appliance is switched on
Message

Align the washing
machine

Check dosage

Sanitize info: Run a
high temp. program
or the "Clean
Machine" program
The message which appears at the end of the program or when the washing
machine is switched on must be confirmed with the OK sensor button.
60
Possible cause and remedy
The smoothing process which the laundry undergoes
at the end of the program could not be carried out
properly.
 Check whether the washing machine is aligned
correctly as described in "Installation and
connection – Levelling the machine".
 Check whether the maximum delivery height of
1 m has been exceeded.
If the fault message appears again, contact the
Service department. The washing machine can still be
used but with reduced functionality.
Excessive foam has built up during washing.
 Check the amount of detergent dispensed.
 With automatic detergent dispensing, check the
dispensing quantity set.
 Observe the instructions on the detergent
packaging and the level of soiling on the laundry.
 If necessary, reduce the dispensing quantity by
increments of 10 %.
A wash program using a temperature above 60 °C has
not been run for a long period of time.
 Turn the program selector to More programs/.
 Touch the  sensor buttons until
appears in the display.
 Touch the OK sensor button to confirm.
The following appears in the display:
 Touch the OK sensor button to confirm.
 Run the
Clean Machine
clean machine or a universal powder detergent.
The washing machine is cleaned which prevents
bacteria and odour buildup.
Maintenance
Clean Machine
program using the Miele