A Message Appears In The Display At The End Of The Programme - Miele TX2070 Operating Instructions Manual

Problem solving guide

A message appears in the display at the end of the programme

Message

Check dosage

Hygiene info

Check filter + jet
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
58
Cause and remedy
Excessive foam has built up during washing.
 Use less detergent next time, and follow the man-
ufacturer's recommended dosage amounts on the
packaging.
A programme using a temperature above 60 °C has
not been run for a long time.
 In order to prevent bacteria and unpleasant odours
building up in the machine, run the Maintenance
wash programme using Miele machine cleaner or
powder detergent.
The pumps are dirty.
 Clean the pumps as described in "Problem solving
guide - Opening the door in the event of a blocked
drain outlet and/or power failure"
 Start the programme again after cleaning the
pumps.
The jet in the top of the door ring is blocked with fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Start the programme again after cleaning the jet.
If the fault message appears again, contact the Ser-
vice Department. The washing machine can still be
used but with reduced functionality.