Wall Mounting - BT Freestyle 130 User Manual

Wall mounting

Your Freestyle 130 can be wall-
mounted by using the bracket
provided.
You can use the bracket as a
template to mark where the screws
should go into the wall.
Before you wall-mount your Freestyle
130, check that:
the wall can support the weight of
•
the base unit and handset;
the position you choose leaves
•
sufficient space so that the base unit
(which is larger than the bracket) is
clear of any obstruction on the wall,
such as a shelf or cupboard. Room
should be left so that the handset can
be placed on charge without
touching any obstructions.
• leave enough room for aerial to be
extended when wall mounted.
Spare parts for your Freestyle 130 are
available from your BT shop or
supplier, or you can contact us on
Lo-call 0845 7697146 between 9.00am
and 5.30pm Monday to Friday.
34
WALL PLUG
WALL
Drill two holes for the screws and
•
insert the wallplugs provided (if
required).
Drive the screws into the wall,
•
leaving about 5mm free on which
to mount the bracket.
Hook the bracket over the screw
•
heads to check if it fits correctly,
then remove again.
Make sure that the power supply
•
and the telephone cables are
connected to the base unit, then
fit the cables into the channels on
the bottom of the base unit.
Clip the bracket onto the base
•
unit as shown on the next page.
Hook the bracket with the phone
•
attached over the screw heads.
Attach the bracket by
hooking it over the screws
protruding from the wall.
SCREW
28mm