Table of Contents
Advertisement
On-Air 1300 Executive user guide ~ Edition 3 ~ 7th August '01 ~ 3992
Wall mounting
1
1
Push the base-mount
forward onto the rear
of the base.
If wall mounting your BT On-Air 1300 Executive,
use this guide for position.
•
Make sure that you are not drilling into any
hidden wiring and check that the power cable
will reach from the mains socket to the
charger. Switch the power adaptor off at the
mains and remove the adaptor plug from its
socket.
•
Drill two holes 25mm deep using a 3mm drill,
122mm apart to take the wall plugs.
•
Put wall plugs into the drill holes and then
insert both screws. Leave 2-3mm between
the head of the screw and the wall. You are
now able to mount the base to the wall.
•
Fit the base onto the two screws. If necessary,
tighten or loosen the screws for the best fit.
•
Put the handset back in the base and switch
the power back on at the wall socket.
37
All manuals and user guides at all-guides.com
2
Once slotted into the rear
2
of the base, slide upwards
to lock into position.
WALL PLUG
122 mm
WALL
SCREW
122mm
Advertisement
Table of Contents
