Page 2
PTS-04-M400/MX915 Parts List T15 L-Key 1x 714904 T20 L-Key 1x 714997 T25 L-Key 1x 71489 800.524.2744 InnovativeWorkspaces.com PAGE 2 OF 9...
Page 3
Mounting hardware not included. Use appropriate hardware for your mounting surface. IMPORTANT: Determine cable routing prior to installing mount. This will ensure the mount is installed in the correct orientation for your installation. Above Surface Cable Routing Locate the mount cable exit and plan your installation accordingly.
Page 4
ROTATION NO ROTATION Placement of the two rotation stop screws in the outter There are rotation stop ribs underneath the top portion ring determine the amount of payment terminal rotation. of the mount that can be placed directly over the rotation You can remove the screws from their original location stop screw or pin.
Page 5
When placing the top of the mount onto the base, ensure the rotation stop ribs fall in between the rotation stops that were set in place in Step 2. Or in a no rotation configuration, the ribs must be placed over top the rotation stop screw or pin. HOW TO RELEASE MOUNT Locate the release tab inside the mount.
Page 6
800.524.2744 InnovativeWorkspaces.com PAGE 6 OF 9...
Page 7
You may need to loosen the screws to allow the device to slide into place on the mount. 800.524.2744 InnovativeWorkspaces.com PAGE 7 OF 9...
Page 8
800.524.2744 InnovativeWorkspaces.com PAGE 8 OF 9...
Page 9
ADJUSTMENT FEATURE To adjust the tilt friction, remove the hex nut covers and tighten or loosen the 13mm hex nut while securing the pivot screw on the inside of the mount with a 14mm wrench. Adjust both sides as needed. 14mm 13mm 800.524.2744 InnovativeWorkspaces.com...
Need help?
Do you have a question about the PTS-04-M400/MX915 and is the answer not in the manual?
Questions and answers