Select Paper Path "Pp" 03H 00H 00H M1 M2 - Epson ET-7750 Programming Manual

6.1.10 Select paper path "PP" 03H 00H 00H m1 m2

[Format]
"PP" 03H 00H 00H m1 m2
[Parameters]
The parameter "m1" and "m2" are each one byte binary data.
The "m1" describes paper is continuous type or a single sheet in CSF or a manual inserted sheet as shown
below.
Paper path
Rear ASF
Cut Sheet Upper Front
Cut Sheet Lower Front
Upper then Lower Front
Auto Select *1
CD-R
[Function]
Select paper path to be used for the temporary default.
The previous setting will be kept if the parameter "m1" and "m2" exceeds its limit.
Also, this command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.
*1:
If the paper handling function is Enabled by the panel, a feeding path is automatically selected Upper Front,
Lower Front or Rear ASF by the paper size and type.
If the paper handling function is Disabled by the panel, a feeding path is automatically selected Upper Front,
Lower Front or Rear ASF by the paper size. Paper type is not considered.
The order of the paper path selection:
1.
2.
3.
Revision: 1
Upper Front
Lower Front
Rear ASF
m1 m2
01H 00H
01H 01H
01H 02H
01H FDH
01H FFH
02H 01H
2018/2/26
Page: 76