D-Link AirXpert DWL-7000AP Manual page 15

Using the Configuration Menu (continued)
Advanced > Performance
The default Performance settings are shown in the illustration above.
Turbo Setting:
Frequency: The frequency range will be displayed.
Channel: The default channel for 802.11a is 36.
The default channel for 802.11g is 6.
Data Rate: Select the transmission rate for the network
Beacon Interval:
a wireless network. Specify a Beacon interval value (20-1000.) Default (100) is
recommended.
DTIM: (Delivery Traffic Indication Message) Enter a value between 1 and 255 for the
Delivery Traffic Indication Message (DTIM.) A DTIM is a countdown informing clients
of the next window for listening to broadcast and multicast messages.
Fragment Length:
experience a high packet error rate, you may slightly increase your Fragmentation
Threshold within the value range of 256 to 2346. Setting the Fragmentation
Threshold too low may result in poor performance.
RTS Length: This value should remain at its default setting of 2346. If you
encounter inconsistent data flow, only minor modifications to the value range
between 256 and 2346 are recommended.
Transmit Power:
security purposes if you wish to limit the transmission range.
*"Maximum wireless signal rate based on IEEE Standard 802.11a and 802.11g specifications. Actual data throughput will vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network overhead lower actual data throughput rate."
Select Enabled or Disabled. The default setting is Disabled.
Beacons are packets sent by an Access Point to synchronize
This value should remain at its default setting of 2346. If you
Adjust the transmission range here. This tool can be helpful for
Wireless Band:
Select 802.11a
(up to 72 Mbps
speed in turbo
mode in the 5GHz
range) or 802.11g
(up to 54 Mbps*
speed with AirPlus
adapters.)
15