Table of Contents
Advertisement
Security
Security System
Your cordless telephone uses a digital coding security system to prevent unauthorized use of your
telephone line by another nearby cordless telephone. The system has its own identifying signal
created by microcomputers in both the BASE UNIT and the HANDSET.
Security Code
This telephone has an internal security code with 65.536 possible combinations.
Resetting Security Code and Channel Information
Communication between the HANDSET and the BASE UNIT may not be possible in any of the
following situations:
1. After a power failure
2. After relocating the BASE UNIT by disconnecting the AC ADAPTER.
3. After replacing the HANDSET BATTERY PACK.
To reset, place the HANDSET on the BASE UNIT for 2 to 5 seconds.
Multi- Channel Access
Your cordless telephone lets you select a channel from the 40 frequencies available to transmit
signals between the BASE UNIT and HANDSET. When you notice interference from other cordless
telephone, change to another channel by pressing the
IMPORTANT
When you hear interference, press the
scan
delete
button to change the operating
scan
delete
button on the HANDSET.
channel.
Recharging the BATTERY PACK
BATTERY Type
Use the following type and size of BATTERY PACK:
Cordless Telephone BATTERY PACK
3.6V,600mAh
U.S. Electronics Inc.
Ni-MH Battery Pack: model B655
This BATTERY PACK is available through:
U.S. Electronics Service Center
105 Madison Avenue
New York ,NY 10016
1-800-825-5208
NOTES: 1. During a power interruption, the BASE UNIT does not operate, and a phone
conversation cannot be made on the HANDSET.
2. A "beep" will be heard when the HANDSET is properly positioned in the BASE
UNIT CHARGE CRADLE and charging.
KEYPAD face up, in the BASE UNIT will also prevent the HANDSET from falling.
Recharging the BATTERY PACK
The nickel metal hydride (Ni-MH) BATTERY PACK in the HANDSET can be recharged many times
using the built-in charger in the BASE UNIT.
When the BATT LOW symbol appears on the LCD Screen, a "beep" sound will be heard every 10
seconds. This indicates that the BATTERY PACK needs to be recharged.
Charge the BATTERY PACK at least once every 90 days of non-use to avoid battery failure. When
the BATTERY PACK can no longer be charged, replacement of the BATTERY PACK will be
necessary.
The BATTERY PACK used in your telephone may develop a condition known as "MEMORY". Once
subjected to a regular short discharging routine, the BATTERY PACK assumes the discharging
pattern it was subjected to. This is known as a "MEMORY" condition which cause rapid discharging
thereby shortening the BATTERY PACK charge span. If you believe your BATTERY PACK has
developed a "MEMORY" condition, do not charge the HANDSET until the BATT LOW symbol
appears on the LCD Screen. When the BATT LOW symbol appears on the LCD Screen, charge the
HANDSET fully for 12 hours.
IMPORTANT
In order to get maximum life from the HANDSET
BATTERY PACK, be sure to charge the HANDSET for 12
hours before initial use.
Securely positioning the HANDSET,
Advertisement
Table of Contents
