Page 1
Homeowner’s Installation Instructions & Operating Manual Model: ES100 These Instructions cover Charlton & Jenrick “E” Stove Quality Products Produced by Charlton & Jenrick Ltd Your product may differ slightly from this illustration Please read the instructions carefully before installation or...
Page 2
IMPORTANT INFORMATION Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. This heater must be earthed. If in any doubt consult a suitable competent person. In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by utility.
Page 3
(490) PARTS AND HARDWARE LIST Part Quantity Stove with insert Instruction Manual Remote Control AAA Battery 2pcs Vermiculite 1pack Clear Stones 1pack Imitation Logs 4 pcs INSTALLATION NOTE: Do Not use this Electric Stove if any part has been under water. Immediately call a qualified service technician to inspect and to replace any part of the electrical system if necessary.
Page 4
Installation of stove: Step1: Unpack and take away Step2: Put the stove in the required position. Adjust feet the stove and parts. to ensure it is level. Open the door of the stove and arrange the vermiculite, clear stones and imitation logs on the plastic surface in a pleasing arrangement of your choice.
Page 5
Multifunction Infrared Remote Handset. To Reset the Heater Your heater includes a protection system that shuts off the heater if it overheats for any reason: 1) Turn unit to off. 2) Unplug unit wait 5 minutes. 3) Plug in and turn on. ●...
Page 6
Resetting the Thermal Cutout Switch The appliance is fitted with an Electronic Safety Control (E.S.). This is a safety device, which switches off the fire if, for any reason, the appliance overheats, e.g. when covered. If the heater stops operating whilst the flame effect continues normally, this indicates that the E.S.
Need help?
Do you have a question about the ES100 and is the answer not in the manual?
Questions and answers