Check The Position Of The Detergent Flap; Setting A Programme; Starting A Programme With The Delay Start - Zanussi Z714W43BI User Manual

CHECK THE POSITION OF THE DETERGENT
FLAP
1. Pull out the detergent dispenser until it stops.
2. Press the lever down to remove the dispenser.
3. To use powder detergent, turn the flap up.
4. To use liquid detergent, turn the flap down.
With the flap in the position DOWN:
• Do not use gelatinous or thick liquid
detergents.
• Do not exceed to liquid detergent dose
indicated on the flap.
• Do not set the prewash phase.
• Do not set the delay start function.
5. Measure out the detergent and the fabric
conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause a blockage
when you close the drawer.
24

SETTING A PROGRAMME

1. Turn the programme dial to select the desired
washing programme.
The indicator of the Start/Pause
The display shows an indicative programme
duration.
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons.
If a selection is not possible an
acoustic signal sounds.
STARTING A PROGRAMME
Touch the Start/Pause
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. programme dial on a wrong
position).
The related indicator stops flashing and stays on.
The programme starts, the door is locked. The
display shows the indicator
STARTING A PROGRAMME WITH THE DELAY
START
1. Touch the Delay Start button until the display
shows the desired delay time. The related indicator
comes on.
2. Touch the Start/Pause
door locks and starts the countdown of the delay
start. The display shows the indicator
When the countdown is completed, the programme
starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause
appliance. The related indicator flashes.
2. Touch the Delay Start button repeatedly until
the display shows .
3. Touch the Start/Pause
start the programme immediately.
Changing the delay start after the countdown
has started
To change the delay start:
1. Touch the Start/Pause
appliance. The related indicator flashes.
button flashes.
button to start the
.
button. The appliance
.
button to pause the
button again to
button to pause the