Assembly - Craftsman 151.74580 Operator's Manual

UNPACKING
This product requires assembly.
■ Carefully remove the product and any
accessories from the box. Make sure that all
items listed in the packing list are included.
Do not use this product
WARNING!
if any parts on the Packing List are already
assembled to your product when you unpack
it. Parts on this list are not assembled to the
product by the manufacturer and require
customer installation. Use of a product that
may have been improperly assembled could
result in serious personal injury.
■ Inspect the product carefully to make sure
no breakage or damage occurred during
shipping.
■ Do not discard the packing material until
you have carefully inspected and satisfactorily
operated the product.
■ If any parts are damaged or missing, do not
operate the product. Return it for replacement
to the retailer from which it was purchased.
151.74580 (KIT) PACKING LIST
Line Trimmer Attachment (Upper Shaft &
Lower Shaft)
Safety Guard with Screws
Auxiliary Handle Assembly with Locking Knob
Flower Guard
(1) 24V Max* 2.5 Ah Lithium-Ion Battery
(1) 24V Max* Battery Charger
Operator's Manual
151.74982 (TOOL ONLY) PACKING LIST
Line Trimmer Attachment (Upper Shaft &
Lower Shaft)
Safety Guard with Screws
Auxiliary Handle Assembly with Locking Knob
Flower Guard
Operator's Manual

ASSEMBLY

WARNING!
or missing do not operate this product until
the parts are replaced. Use of this product
with damaged or missing parts could result in
serious personal injury.
WARNING!
starting that could cause serious personal
injury, always remove the battery pack from
the product when assembling parts.
WARNING!
this product or create accessories not
recommended for use with this product. Any
such alteration or modification is misuse and
could result in a hazardous condition leading
to possible serious personal injury.
ATTACHING THE AUXILIARY HANDLE
See Figures 2-3, page ii
■ Loosen the locking knob from the auxiliary
handle. (Fig. 2)
■ Align the auxiliary handle with the power
head shaft.
■ Adjust the auxiliary handle to the most
comfortable position.
■ Insert the bolt (B) in the hole on the
auxiliary handle, tighten the locking knob (A)
and clamp down to secure handle. (Fig. 3)
NOTE: Auxiliary handle can be mounted
from either side of the shaft to accommodate
personal preference of use.
CONNECTING LOWER AND UPPER
SHAFTS
See Figure 4, page ii
■ Align the upper shaft with the lower shaft.
The triangle-shaped recesses must face each
other.
■ Insert the upper shaft into the lower shaft.
■ Fasten both shafts with the locking collar.
9 ― English
If any parts are damaged
To prevent accidental
Do not attempt to modify