Craftsman 151.74580 Operator's Manual page 10

ATTACHING THE FLOWER GUARD
See Figures 5-8, page iii
■ Align and seat the steel flower guard rails
into the 2 recessed channels on either side of
the motor housing.
■ Once aligned and with the steel rails of the
flower guard seated into housing channels,
slide the guard forward until the closed end of
the guard is against the motor housing.
■ With the two steel rails exposed, align the
two holes in the plastic toe pad with the end
of the steel rails of the guard and snap into
place securely.
ASSEMBLY
ATTACHING THE SAFETY GUARD
See Figure 9, page ii
WARNING!
the safety guard is sharp. Avoid contact with
the blade. Failure to avoid contact can result
in serous personal injury.
■ Align the safety guard with the spool head.
■ Secure guard by tightening the mounting
screws with a screwdriver.
10 ― English
The line cut-off blade on