Table of Contents
Advertisement
steady long flashes
continuous on
One long, two short flashes
One long, three short flashes
One long, four short flashes
One long, five short flashes
One long, six short flashes
One long, seven short flashes
One long, eight short flashes
One long, nine short flashes
steady short flashes
One long, eleven short flashes
In the event of a Firmware Reload Required error at startup, proceed
according to instructions given in the PS Admin User's Guide ("PS Admin
Administration" section, under the heading "Upgrading the Print Server's
Internal Firmware").
In the event that any of the other listed error conditions is encountered on
startup, contact your dealer for correction of the fault.
Operational Test
The PS Admin software includes a Print Test function for confirmation of
connections and functions. That operational test can be performed after you
have completed installation of the PS Admin software, and the PS Admin
procedures for configuring the DP-301. See instructions given in the PS
Admin User's Guide ("Getting Started Setting up Your Print Server"
section, under the heading "Testing your Print Server").
Velcro-mounting the DP-301
The DP-301 can stand on the printer's tabletop, or may be Velcro-mounted
to a side panel of the printer or another suitable surface next to the printer.
To prepare for Velcro-mounting, separate the two parts of the supplied
Unpacking and Installation
DP-301 Print Server Hardware Guide
Firmware Reload Required
DRAM Error
Timer INT Error
Flash Protected
Flash ID Error
Flash Erase / Program Error
LAN Controller Error
LAN Memory Error
Parallel Controller Error
LPT Error
EERPROM Error
LAN I/O Base error
9
Advertisement
Table of Contents
