Makita BTD044 Instruction Manual page 10

► 1. Rear cover 2. Screws
Use a screwdriver to remove two screws then remove
the rear cover.
1
► 1. Spring 2. Recessed part 3. Arm
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit screw-
driver of slender shaft or the like.
► 1. Carbon brush cap
Use pliers to remove the carbon brush cap of the car-
bon brushes. Take out the worn carbon brushes, insert
the new ones and replace the carbon brush cap in
reverse.
1
2
Make sure to place the lead wire in opposite side of the
arm.
2
2
3
► 1. Lead wire 2. Spacer
Put the lead wires between the spacer and the side of
brush holder.
1
► 1. Hole 2. Carbon brush cap
Make sure that the carbon brush caps fit into the holes
in brush holders securely.
Reinstall the rear cover and tighten two screws
securely.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
10 ENGLISH
1
1
2