Advertisement
For instructions on configuration, please see your User's Manual.
APPENDIX
Connecting Your Network Cable
Category 5 UTP cable can be used for both
Fast Ethernet cabling and for traditional
Ethernet cabling.
Connecting for Fast Ethernet cabling
Cat5 cable is required for Fast Ethernet
operation. The maximum cable length between
the DFE-680TX/TXD and the supporting hub is
300 ft. The cable must be straight (not a
crossover cable), with an RJ-45 plug at each end.
Connecting for traditional (10Mbps) Ethernet cabling
Category 3, Category 4, and Category 5 UTP cable, as well as EIA/TIA-568 100-ohm STP
cable, all qualify under traditional Ethernet cabling rules. The maximum cable run
between the DFE-680TX/TXD and the supporting hub is 300 ft.
The cable must be straight (not a crossover cable) with an RJ-45 plug at each end.
APPENDIX
To check for the proper installation
of your DFE-680TX/TXD, please
click on START > SETTINGS >
CONTROL PANEL>, double click
on the SYSTEM icon. At the
SYSTEM PROPERTIES window,
click on the DEVICE MANAGER
tab. Your DFE-680TX/TXD will
appear under NETWORK
ADAPTERS, as shown.
A
B
12
Advertisement
