Table of Contents
Advertisement
5.7.2.4.
Advanced Settings
The page includes the following fields:
Object
Regional
Mode
RF Output Power
Packet Threshold
Beacon Interval
Maximum Users
Coverage Threshold
Distance
Aggregation
Figure 5-27 Advanced Settings
It shows FCC or ETSI depending on the firmware.
Select 802.11N/G or 802.11B/G in 2.4G AP
Select 802.11A or 802.11AN in 5G AP
The range of transmit power is 100%, 75%, 50%, 25% or 12.5%. In
case of shortening the distance and t he coverage of the wireless
network, input a smaller value to reduce the radio transmission power.
When the length of a d ata packet exceeds this value, the router will
send an RTS frame to the destination wireless node, and the latter will
reply with a CTS frame, and thus they are ready to communicate. The
default value is 2346.
Set beacon interval, the value range is from 100 to 1024. The default
value is 100.
The maximum users are 64.
The coverage threshold is to limit the weak signal of clients occupying
session. The default is -95dBm.
Select a specified distance of the two nodes.
A part of the 802.11n standard that allows sending multiple frames per
single access to the medium by combining frames together into one
larger frame. It creates the larger frame by combining smaller frames
-42-
User Manual of WAP-252N/WAP-552N
Description
Advertisement
Table of Contents
