Wisp Mode (Client Router); Wisp Mode - Planet WAP-252N User Manual

5.4

WISP Mode (Client Router)

In WISP mode, all Ethernet ports are bridged together and wireless client will connect

ISP access point.
The NAT is enabled and PCs in Ethernet port share the same IP to ISP through wireless

LAN.
User must set the wireless to client mode first and connect to the ISP AP in Site-Survey

page.
The connection type can be set up on the WAN page by using PPPoE, DHCP client and

static IP.
Click "Wizard"  "WISP Mode" and the following page will be displayed. This section allows you to configure
the WISP mode.
User Manual of WAP-252N/WAP-552N
Figure 5-11 WISP Mode
-28-