Table of Contents
Advertisement
PROBLEM
Red LED & Green LED
do not illuminate on
BATTERY CHARGER
Battery pack has low
capacity
Trigger Switch will not
depress
Cordless Drill does
not start when Trigger
Switch is depressed
Page 12
TROUBLESHOOTING
LIKELY CAUSE(S)
1. Battery not installed in Charger
correctly
2. Charger is not plugged in
1. Battery is not fully charged
2. Battery is at the end of duty cycle
1. FWD/REV Switch may be in the
middle locking position
1. Battery is completely discharged
2. Defective Battery
3. Cordless Drill is defective
NOTES
SOLUTION(S)
1. Remove Battery and reinstall in the Charger
until a "click" is heard
2. Plug in Charger
1. Do not remove Battery from the Charger until
the Green LED is illuminated
2. Battery has exceeded 100 charging cycles
1. Slide the FWD/REV Switch to the left or right
to unlock the Trigger Switch
1. Charge Battery or replace with a fully charged
Battery
2. Replace Battery. Email parts@rikontools.com
3. Contact Technical Support by emailing
techsupport@rikontools.com
Advertisement
Table of Contents
