RECORDING GPS DATA (I)
Connect ECO PS-2 GPS to the camera and turn the camera on.
If ECO PS-2 GPS is properly connected, the LED of ECO PS-2 GPS will start
blinking and a
GPS
icon will be shown in the top control panel / on the LCD
monitor. The blinking LED means that the GPS receiver is searching for a
signal.
The
GPS
icon will stop blinking once signal has been established and the
camera is ready to record the current position.
STATUS LED
(on GPS)
(on camera)
Blinking Icon
Blinks
Blinks
Steady On
NOTE
LED on ECO PS-2 GPS only represents the status of ECO PS-2 GPS but not the reception of GPS data to the camera.
GPS data is only recorded when
Please make sure that the
DI-GPS® IS A REGISTERED TRADEMARK OR A TRADEMARK OF DAW N TECHNOLOGY LIMITED.
NIKON D5, D4, D4S, D3, D3S , D3X, D500,D810A, D810, D8 00, D800E, D700, D300, D300S, D2XS, D2X, D2HS,
D200 D5600, D3400, D7200, D5500, D3300, DF, D5300, D610, D600, D75 0, D7100, D7000, D5100, D5000, D3200,
D3100, D90 ARE REGISTERED TRADEMARK OR A TRADEMARK OF NIKON CORPORATION IN T HE UNITED
STATES AND/OR OTHER COUNTRIES.
FUJIFILM AND S5 PRO ARE REGISTERED TRADE MARK OR A TRADEMARK OF FUJIFILM U.S.A., INC. IN THE
UNITED STATES AND/OR OTHER COUNTRIES.
GPS ICON
No fix, Signal searching
No Last Position Memory output
No GPS data will be recorded in the photos
No fix, Signal searching
Last Position Memory output with current UTC
date/time to the camera until new fix is available
Icon Steady
Last fixed GPS position will be recorded to the photos
Fix available
ECO PS-2 GPS continuously sends the current GPS
position to the camera.
Icon Steady
GPS
icon is shown in the top control panel / on the LCD monitor of DSLR camera.
GPS
icon is displayed before shooting.
DESCRIPTION
V1.2
8