Recording Gps Data (I) - di-GPS Eco ProFessional PF1 User Manual

RECORDING GPS DATA (I)

Connect ECO PF1 GPS to the camera and turn the camera on.
If ECO PF1 GPS is properly connected, the LED of ECO PF1 GPS will start blinks and a
displayed on the LCD panel / LCD monitor. The blinking LED means the GPS receiver is searching for a
signal. The GPS icon will stop blinking once signal has been established and the camera is ready for
record the current position.
STATUS LED
(on ECO PF1
GPS)
Blinks
Steady On
NOTE

LED on ECO PF1 GPS only represents the status of ECO PF1 GPS, but not the reception of GPS
data to the camera.

GPS data are only recorded when
camera. Please make sure that the
DI-GPS® IS A REGISTERED TRADEMARK OR A TRADE MARK OF DAW N TECHNOL OGY LIMITED.
NIKON D2HS, D2X, D2XS, D200, D3, D3S, D3 X, D300, D300S, D600, D700, D800, D90, D3100, D3200, D5000,
D5100, D7000, D7100 AND P7700 ARE REGISTERED TRADEMARK OR A TRADEMARK OF NIKON
CORPORATION IN THE U NITED STATES AND/OR OTHER COUNTRIES.
FUJIFILM AND S5 PRO ARE REGISTERED TRADE MARK OR A TRADEMARK OF FUJIFILM U.S.A., INC. IN THE
UNITED STATES AND/OR OTHER COUNTRIES.
GPS ICON
(on camera)
 No fix, Signal searching
 No GPS data will be recorded in the photos
Blinks Icon
 Fix available
 ECO PF1 GPS continuously sends the current GPS
Icon Steady
position to the camera.
GPS icon displayed on LCD panel / LCD monitor of DSLR
GPS icon is displayed before shooting.
GPS
DESCRIPTION
icon will be
V1.1
8