RECORDING GPS DATA (I)
Connect ECO PF1-M GPS to the camera and turn the camera on.
If ECO PF1-M GPS is properly connected, the LED of ECO PF1-M GPS will start blinks and a
will be displayed on the LCD panel / LCD monitor. The blinking LED means the GPS receiver is
searching for a signal. The
camera is ready for record the current position.
STATUS LED
(on GPS)
Blinks
Blinks
Steady On
NOTE
LED on ECO PF1-M GPS only represents the status of ECO PF1-M GPS, but not the reception of
GPS data to the camera.
GPS data is only recorded when
camera. Please make sure that the
DI-GPS® IS A REGISTERED TRADEMARK OR A TRADE MARK OF DAW N TECHNOL OGY LIMITED.
NIKON D2HS, D2X, D2XS, D200, D3, D3S, D3 X, D300, D300S, D600, D700, D800, D90, D3100, D3200, D5000,
D5100, D7000, D7100 AND P7700 ARE REGISTERED TRADEMARK OR A TRADEMARK O F NIKON
CORPORATION IN THE U NITED STATES AND/OR OTHER COUNTRIES.
FUJIFILM AND S5 PRO ARE REGISTERED TRADE MARK OR A TRADEMARK OF FUJIFILM U.S.A., INC. IN THE
UNITED STATES AND/OR OTHER COUNTRIES.
GPS
icon will stop blinking once signal has been established and the
GPS ICON
(on camera)
No fix, Signal searching
No Last Position Memory output
No GPS data will be recorded in the photos
Blinks Icon
No fix, Signal searching
Last Position Memory output with current UTC
date/time to the camera until new fix available
Last fixed GPS position will be recorded to the
Icon Steady
Fix available
ECO PF1-M GPS continuously sends the current GPS
position to the camera.
Icon Steady
GPS
icon displayed on the LCD panel / LCD monitor of DSLR
GPS
icon is displayed before shooting.
DESCRIPTION
photos.
GPS
icon
V1.0
8