Basic Switch Commands - D-Link xStack DGS-3324SRi Command Line Interface Reference Manual

The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create account
config account
show account
delete account
show config
show session
show switch
show switch_mode
show device status
show module_info
show serial_port
config serial_port
enable clipaging
disable clipaging
enable telnet
disable telnet
enable web
disable web
save
reboot
reset
login
logout
Each command is listed, in detail, in the following sections.
create account
Purpose
Syntax
Description
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Parameters
[admin | user] <username 15>
<username 15>
<username 15>
[current_config | config_in_NVRAM]
{baud_rate [115200] auto_logout [never | 2_minutes | 5_minutes |
10_minutes | 15_minutes]}
<tcp_port_number 1-65535>
<tcp_port_number 1-65535>
[log | all]
{[config | system]}
Used to create user accounts.
create [admin | user] <username 15>
The create account command is used to create user accounts
that consist of a username of 1 to 15 characters and a password
of 0 to 15 characters. Up to 8 user accounts can be created.
B S
ASIC
11
C
WITCH OMMANDS
4