D-Link DGS-3224TGR Command Line Interface Reference Manual page 164

DGS-3224TGR Layer 2 Gigabit Ethernet Switch User's Guide
config router_ports
Purpose Used to configure ports as router ports.
config router_ports <vlan_name 32>
Syntax
[add|delete] <portlist>
Description This command allows you to designate a
range of ports as being connected to
multicast-enabled routers. This will ensure
that all packets with such a router as its
destination
enabled router − regardless of protocol, etc.
<vlan_name 32> − The name of the VLAN
Parameters
on which the router port resides.
<portlist> − Specifies a range of ports which
will be configured as router ports. The port
list is specified by listing the beginning port
number and the highest port number of the
range. The beginning and end of the port
list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies
port 4. 3-4 specifies all of the ports
between port 3 and port 4 − in numerical
order.
Restrictions Only administrator-level users can issue
this command.
Example Usage:
To set up static router ports:
will reach the multicast-
160