D-Link DGS-3224TGR Command Line Interface Reference Manual page 148

DGS-3224TGR Layer 2 Gigabit Ethernet Switch User's Guide
Success.
DGS-3224TGR:4#
config link_aggregation
Purpose Used to configure a previously created link
aggregation group.
config link_aggregation group_id <value>
Syntax
{master_port <port>|ports <portlist>|
state [enable|disable]
Description This command allows you to configure a
link aggregation group that was created
with the create link_aggregation command
above.
Parameters <value> − Specifies the group id. The
switch allows up to 32 link aggregation
groups to be configured. The group number
identifies each of the groups.
<port> − Master port ID. Specifies which
port
aggregation group will be the master port.
All of the ports in a link aggregation group
will share the port configuration with the
master port.
<portlist> − Specifies a range of ports that
will belong to the link aggregation group.
The beginning and end of the port list
range
example, 3 would specify port 3. 4 specifies
port 4. 1-4 specifies all of the ports between
(by port number) of
are separated by a dash. For
144
the link