D-Link DGS-3224TG User Manual page 58

Address field. There are two static unicast forwarding types to select from, Permanent and
DeleteOnReset. Enter the port number in the Port field.
Highlight APPLY and press Enter to make the changes current. Use Save Changes from the main
menu to enter the changes into NV-RAM.
Setup Static Multicast Forwarding Table
To edit the IEEE 802.1q Multicast Filtering settings, highlight Configure Static Multicast Forwarding
Table on the Configure Static (Destination-Address Forwarding) Table menu above to access the
following screen:
The Action field can be toggled between Add/Modify and Delete using the space bar. To add a new
entry to the static multicast forwarding table, select Add/Modify and enter the VLAN ID number of the
VLAN that will be receiving the multicast packets. Enter the MAC address of the multicast source, and
then enter the member ports. Each port can be either Egress or a non-member of the multicast group,
on a per-VLAN basis. There are two static multicast forwarding types to select from, Permanent and
DeleteOnReset.
To set a port's multicast group membership status, highlight the first field of (E/-). Each port's
multicast group membership can be set individually by highlighting the port's entry using the arrow
keys, and then toggling between E and – using the space bar.
•
E (Egress Member) – Specifies the port as being a static member of the multicast group.
Egress Member Ports are ports that will be transmitting traffic for the multicast group.
•
– (Non-Member) – Specifies the port as not being a member of the multicast group, but the
port can become a member of the multicast group dynamically.
Highlight APPLY and press Enter to make the changes current. Use Save Changes from the main
menu to enter the changes into NV-RAM.
Figure 6-20. Setup Static Multicast Forwarding Table screen
DGS-3224TG Gigabit Ethernet Switch User's Guide
48