D-Link DGS-3224TG User Manual page 116

The information is described as follows:
•
Time Interval – Select the desired setting between 1s and 60s, where "s" stands for seconds.
•
Record Number – Select number of times the switch will be polled between 20 and 200.
•
Multicast – Counts the total number of good packets that were received by a multicast
address.
•
Broadcast – Counts the total number of good packets that were received by a broadcast
address.
•
Unicast – Counts the total number of good packets that were received by a unicast address.
•
Show/Hide – Check whether or not to display Multicast, Broadcast, and Unicast Packets.
•
Clear – Clicking this button clears all statistics counters on this window.
•
View Table – Clicking this button instructs the switch to display a table rather than a line
graph.
•
View Line Chart – Clicking this button instructs the switch to display a line graph rather than a
table.
Figure 7-30. Rx Packets Analysis window for UMB_cast (Table)
DGS-3224TG Gigabit Ethernet Switch User's Guide
106