D-Link DES-3526 Command Line Interface Reference Manual page 158

create access_profile
frame header fields. Specific values for the rules are entered using
the config access_profile command, below.
ethernet − Specifies that the Switch will examine the layer 2 part of
Parameters
each packet header.
•
•
•
•
•
ip − Specifies that the Switch will examine the IP address in each
frame's header.
•
•
•
•
•
•
•
DES-3526 Layer 2 Fast Ethernet Switch
vlan − Specifies that the Switch will examine the VLAN part of
each packet header.
source_mac <macmask> − Specifies a MAC address mask for
the source MAC address. This mask is entered in a
hexadecimal format.
destination_mac <macmask> − Specifies a MAC address mask
for the destination MAC address.
802.1p − Specifies that the Switch will examine the 802.1p
priority value in the frame's header.
ethernet_type − Specifies that the Switch will examine the
Ethernet type value in each frame's header.
vlan − Specifies a VLAN mask.
source_ip_mask <netmask> − Specifies an IP address mask for
the source IP address.
destination_ip_mask <netmask> − Specifies an IP address
mask for the destination IP address.
dscp − Specifies that the Switch will examine the DiffServ Code
Point (DSCP) field in each frame's header.
icmp − Specifies that the Switch will examine the Internet
Control Message Protocol (ICMP) field in each frame's header.
type − Specifies that the Switch will examine each frame's
•
ICMP Type field.
code − Specifies that the Switch will examine each frame's
•
ICMP Code field.
igmp − Specifies that the Switch will examine each frame's
Internet Group Management Protocol (IGMP) field.
type − Specifies that the Switch will examine each frame's
•
IGMP Type field.
tcp − Specifies that the Switch will examine each frames
Transport Control Protocol (TCP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask
•
for the source port.
150