D-Link DES-3526 Command Line Interface Reference Manual page 127

config link_aggregation
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7 plus port 9:
DES-3526:4#config link_aggregation group_id 1 master_port 1 ports 5-7, 9
Command: config link_aggregation group_id 1 master_port 1 ports 5-7, 9
Success.
DES-3526:4#
config link_aggregation algorithm
Purpose
Syntax
Description
Parameters
DES-3526 Layer 2 Fast Ethernet Switch
master_port <port> − Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of
the ports in a link aggregation group will share the port configuration
with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to
the link aggregation group.
state [enable | disable] − Allows you to enable or disable the specified
link aggregation group.
Only administrator-level users can issue this command. Link
aggregation groups may not overlap.
Used to configure the link aggregation algorithm.
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest | ip_source | ip_destination | ip_source_dest]
This command configures the part of the packet examined by the Switch
when selecting the egress port for transmitting load-sharing data. This
feature is only available using the address-based load-sharing algorithm.
mac_source − Indicates that the Switch should examine the MAC source
address.
mac_destination − Indicates that the Switch should examine the MAC
destination address.
mac_source_dest − Indicates that the Switch should examine the MAC
source and destination addresses
ip_source − Indicates that the Switch should examine the IP source
address.
ip_destination − Indicates that the Switch should examine the IP
destination address.
ip_source_dest − Indicates that the Switch should examine the IP source
address and the destination address.
119