Trim and Tilt
Check reservoir fluid level every three years or
every 300 operating hours. System capacity is
approximately 21 fl. oz. (620 ml).
Tilt the outboard and engage the tilt support.
•
1
1. Tilt support bracket
Remove the fill plug.
•
•
Three Ram System–Add Power Trim/Tilt Fluid
or GM Dexron II, as needed, to bring level to the
bottom of the fill plug threads.
1
Three Ram Trim System
1. Fill cap
Install the fill plug and tighten to a torque of 45
•
to 55 in. lbs. (5 to 6 N·m).
Disengage tilt support.
•
002279
Cycle the unit at least five complete cycles to
•
purge all air from the system. When cycling the
unit, hold the trim switch ON an additional 5 to
10 seconds after the unit reaches the end of its
travel before activating the switch in the oppo-
site direction.
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
MAINTENANCE
LUBRICATION
WARNING
3
004277
79