Connecting Network Cable; Power On - D-Link DES-1009G User Manual

Connecting Network Cable

The DES-1009G Gigabit Ethernet Switch supports one
10/100/1000Mbps NWay Gigabit Ethernet port and eight
10/100Mbps NWay Fast Ethernet ports. Port 1 to port 8 support
10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in
half and full duplex mode. Port 9 is a NWay Gigabit Ethernet port,
it supports 10Mbps, 100Mbps and 1000Mbps, it runs both half
duplex and full duplex while it's running in 10Mbps or 100Mbps,
but it can only run full duplex mode in 1000Mbps.
Note: For having best connection, please check your connecting speed.
Port 1 to port 8 are MDI-X type port, you can use standard cable
to connect to the NIC. If you want to connect to the hub or switch,
you have to connect the uplink port to the other hub's MDI-X type
port by using the standard cable.
Port 9 is Auto-MDI type ports, this port can auto transform to
MDI-II or MDI-X type, so you can just make an easy connection
without worrying if you are using a standard or crossover cable.

Power on

The DES-1009G Gigabit Ethernet Switch can be used with AC
power sources 100 - 240 VAC, 50 - 60 Hz. The Switch's power
supply will adjust to the local power source automatically and may
be turned on without having any or all LAN segment cables
connected.
8