Connecting Network Cable; Ac Power - D-Link DGS-1216T User Manual

Connecting Network Cable

The Switch supports 1000Mbps Gigabit Ethernet that runs in Auto-negotiation
mode, 10Mbps Ethernet or 100Mbps Fast Ethernet that runs both in half- and
full-duplex mode, and 1000Mbps Gigabit Ethernet that runs in full-duplex mode
using four pairs of Category 5 Cable.
These RJ-45 ports are Auto-MDI type port. The Switch can auto
transform to MDI-II or MDI-X type, so you can just make an easy
connection that without worrying if you are using a standard or
crossover RJ45 cable.

AC Power

The Switch uses a 100-240V AC, 50-60 Hz AC power supply. The
power switch is located at the rear of the unit adjacent to the AC
power connector and the system fan. The Switch's power supply
will adjust to the local power source automatically and may be
turned on without having any or all LAN segment cables
connected.
11