Changing settings
You can change some of the factory
default settings by selecting an
alternative.
Please consult the chart for the
individual settings that can be changed.
The factory settings are marked with an
asterisk * in the chart.
To change a setting, proceed as
follows:
Touch .
and appear in the display and the
symbol flashes.
Touch OK.
appears in the display.
Use the time selector to select the
setting you wish to change ( to
and ). Turn it until the setting
required shows in the display.
Touch OK to call up the setting.
The currently valid status appears in the
display, e.g. etc.
54
Turn the time selector if you wish to
change the status (see chart), and
confirm your entry by touching OK
(for and , touch OK for approx.
4 seconds).
The change to the setting is then stored
in memory. will appear in the display
again together with the number for the
setting.
The other settings can be changed in
the same way.
Touch if you do not want to change
a setting and want to switch to another.
Touch if you do not want to
change any more settings.
The altered settings are retained after
a power cut.
If there is too long a pause before the
next entry, the time of day will reappear
in the display. If this happens, repeat
your entries.